Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 1 subscriber
  • Views 821 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SSH-Sentinel behind a router/fw

quasar3c279
Hello there,

I've set up a Roadwarrior-VPN with the Sentinel and the Astaro V4. Everything works fine if I'm directly connected to the Internet via modem or isdn. but if i'm behind a router/fw e.g. AstaroV4 the exchange of the certificates doesn't work and the creation of the tunnel fails!

can anybody helpme?

thanks...

regards,
mario   


This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to medic
    Be advised that if IPSec pass-thru is enabled on the roadwarrior's NAT'ing fw that will break NAT-T if it is enabled and will cause connectivity problems if NAT-T is enabled on the client.

    Per the ASL 4.0 on-line help:

    Make sure that the natting device has IPSec-passthru turned off, because this can break the use of NAT-Traversal.

    Good Luck!  
  • 0 in reply to Brent_Gay
    Hi,

    thanks for your answers. I've tried all this, but it doesn't work.
    NAT-T enabed on both sides (Astaro -- SSH-Sentinel). IPSec path-thru disabled on the roadwarriors side.

    The connection still fails. If i make a direkt connection everything works fine!

    More suggestions?

    Thanks,
    Mario  
Cookie Information Banner