Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 1 subscriber
  • Views 676 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VPN Host-to-Network Problems with NAT ?

netadmin
Is it possible to setup a VPN Host-to-Net connection beause i think i have problems because of NAT on both sides

my configuration :
(Internal Host)---(Sentinel 1.4) (DSL-Router)====(VPN through internet)====(Router) ---(ASL 4.017)---(Internal Network)
When I re-enabled the IPSec pass-through the IKE Phase-1 
and  Phase-2 works.
But i Have no connection behind ASL 
Thanks for your Help! 
  


This thread was automatically locked due to age.
  • 0
    Do you have Nat-traversal enabled on your client an on the ASL? Also ensure, that don´t have a 32 bit mask set as virtual ip in the SSH Sentinel configuration.
    You can post the error of your log, to find out where the problem is.  
Cookie Information Banner