This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PPTP Works Sorta

I'm Using ASL 4.0 and a w2k pptp client.

When I enable the connection. All seems to go well my ID is authenticated, my machine is registered and I am allowed access.

However I can see none of the servers in my network. Pings are unresponsive "request timed out"

my internal net is 10.0.2.X
the pptp net is 10.0.3.x

I have set up packet filter rule to Private_Network_10.0.0.0 to allow any service to VPN NET and VPN net to allow any service from Private_Network_10.0.0.0

The interesting thing I have noticed is that the VPN address is assigned as 10.0.3.2 with a subnetmask of 255.255.255.255

Any insight, help or sugesstions would be great.

Thanks,

jim   


This thread was automatically locked due to age.
Parents

  • I got the same problem, I can't connect to the hosts on the inside even if I allow ICMP forward, Ping forward and Traceroute forward. I allow ANY ANY bothways between PPTP-pool and the inside.
    On the other side I can ping and connect to everything on the DMZ just fine, even that I don't have any rule that allow that...

    I'm running 4.006 and the ASL is the default gateway for all computers on the inside and the DMZ.

    /Tote 
Reply

  • I got the same problem, I can't connect to the hosts on the inside even if I allow ICMP forward, Ping forward and Traceroute forward. I allow ANY ANY bothways between PPTP-pool and the inside.
    On the other side I can ping and connect to everything on the DMZ just fine, even that I don't have any rule that allow that...

    I'm running 4.006 and the ASL is the default gateway for all computers on the inside and the DMZ.

    /Tote 
Children
No Data