This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sentinel 1.4 with NAT-T finally working,BUT...

Hi,

I finally got the SSH Sentinel in my home office behind a dsl-router working with our asl4 in our office. NAT-T works,
WONDERFUL !!

Only Problem :
If I establish a ipsec VPN NAT-T Tunnel and do a permanent ping to an internal mnachine, it does the permanent ping for about 5 Minutes and THEN timeouts and has no connection anymore.

Sentinel says the tunnel is still alive!

After restart of sentinel everythings works again
(for about 5 mins).

Any idea?

best regards from Germany
Jörg

This thread was automatically locked due to age.

Parents

0 Andy_01 over 22 years ago

could you please post the Astaro version you use and the build number of the SSH Sentinel?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Andy_01 over 22 years ago

could you please post the Astaro version you use and the build number of the SSH Sentinel?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 oliver.desch over 22 years ago in reply to Andy_01

Hi Joerg, Nazo and Andy,

I have setup a testing environment today (Nazo - you can say you to me ;-) ) and
tried to reproduce the error. As far as I could see it may happen if the router in front
of the client does IPSEC-passthrough, please try to switch it off.

read you
o|iver
Cancel
Vote Up 0 Vote Down

Cancel