This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XP_IPsec 2 Astaro VPN how to?

Hi, I searched the BB but I can't find any hint to use the integrated IPSEC client from XP [:S]
So, has anyone already tried to make such a connection?
And have you been successful?
Thanx

This thread was automatically locked due to age.

Parents

0 Andreas Steffen over 22 years ago

Try Marcus Müller's W2k/XP ipsec tool and howto found at

http://vpn.ebootis.de

Regards

Andreas
Cancel
Vote Up 0 Vote Down

Cancel
0 danielrm26 over 22 years ago in reply to Andreas Steffen

Anyone get this to work? I am about to try here on my end; I'll let you guys know how it goes.
Cancel
Vote Up 0 Vote Down

Cancel
0 Andreas Steffen over 22 years ago in reply to danielrm26

Dozens of installations under Windows 2000 and XP [:)]

Not with ASL 4.0 on the other end but with FreeS/WAN and X.509
certificates. Since ASL 4.0 is based on SuperFreeS/WAN it should work, too.

Andreas
Cancel
Vote Up 0 Vote Down

Cancel
0 danielrm26 over 22 years ago in reply to Andreas Steffen

Could you point me in the direction of the docs you used? I want to go from XP to Astaro 4.x.
Cancel
Vote Up 0 Vote Down

Cancel
0 Andreas Steffen over 22 years ago in reply to danielrm26

There is a HOWTO written by Nate Carlson under the Link

http://www.natecarlson.com/linux/ipsec-x509.php

just ignore the certificate generation and FreeS/WAN
configuration sections since they are handled by the
ASL 4.0 GUI.

Regards

Andreas
Cancel
Vote Up 0 Vote Down

Cancel
0 danielrm26 over 22 years ago in reply to Andreas Steffen

When I run the ipseccmd command on the client, I am getting the following error:

"left=" not defined !

I am not sure why I am getting this. I have left it the same as in the example and tried defining an IP in multiple different ways with no luck.

Any ideas on how to get it to parse this?
Cancel
Vote Up 0 Vote Down

Cancel
0 ClausP over 22 years ago in reply to danielrm26

[ QUOTE ]
When I run the ipseccmd command on the client, I am getting the following error:

"left=" not defined !

I am not sure why I am getting this.  I have left it the same as in the example and tried defining an IP in multiple different ways with no luck.

Any ideas on how to get it to parse this?

[/ QUOTE ]

left=%any

For one side the adress %any is supported. It will be replaced by your LAN or WAN IP Adress

greetz
Claus
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 ClausP over 22 years ago in reply to danielrm26

[ QUOTE ]
When I run the ipseccmd command on the client, I am getting the following error:

"left=" not defined !

I am not sure why I am getting this.  I have left it the same as in the example and tried defining an IP in multiple different ways with no luck.

Any ideas on how to get it to parse this?

[/ QUOTE ]

left=%any

For one side the adress %any is supported. It will be replaced by your LAN or WAN IP Adress

greetz
Claus
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data