This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Packet Filter Rules to allow PPTP connect

This might seem basic but... I've searched the forums and manual but can't seem to find a definitive answer.
Do I need to create rules like...
Any--PPTP--Eth1_Interface--Allow
Any--GRE--Eth1_Interface--Allow
to establish a PPTP connection to the Eth1 interface (external)? Or are they automatic when enabling Road Warrior access?
I understand that I'll need rules like...
PPTP-Pool--HTTP--Web_serv--allow etc. to allow the PPTP_Pool addresses access to anything.

This thread was automatically locked due to age.

0 oliver.desch over 22 years ago

Jim,

the firewall sets all operational filters itself.

You need packet filters for your clients,
e.g. PPTP_IPs ANY INTERNAL ALLOW, this is
an example not a suggestion [;)]

read you
o|iver

[size="1"][ 26 November 2002, 01:25: Message edited by: oliver.desch ][/size]
Cancel
Vote Up 0 Vote Down

Cancel
0 JimmyM over 22 years ago in reply to oliver.desch

Thanks, Oliver. I had other problems that were causing my 619 error. Everything works as intended.
Cancel
Vote Up 0 Vote Down

Cancel