This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSec VPN Net 2 Net break down

I have installed a Net 2 Net connection via IPSec between ASL and WatchGuard Firebox. If I start up the VPN connection everything works fine. After a while (about 2 hours) the tunnel get the status "%hold" and no further connection is possible.
The only way to get the connection again work is to restart the IPSec connection. After the period the same problem happens.

Thanks for your help.

Christian

This thread was automatically locked due to age.

Parents

0 Andy_01 over 23 years ago

sounds like the SA lifetime aren't the same on both boxes, i don't know what watchguard uses by default and if you can change that, but on the Astaro side you can adjust this in the policy.
Cancel
Vote Up 0 Vote Down

Cancel
0 Martin Kivi over 22 years ago in reply to Andy_01

I also have the same problem... but mine accours only a cuple of times in the day... when no one is using the vpn it seems like its up all the time

Please tell me if you have a good solution to this.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Martin Kivi over 22 years ago in reply to Andy_01

I also have the same problem... but mine accours only a cuple of times in the day... when no one is using the vpn it seems like its up all the time

Please tell me if you have a good solution to this.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data