This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Astaro Net-to-Net

Hello,

I try to setup VPN tunnel between our officess, each is using Astaro Firewall 2.x.
The configuration is
BOX 1 : eth0: 194.1.222.1/24 - external
eth1: 192.168.1/24 - internal

BOX 2 : eth0 194.1.222.20/24 - extrenal
: eth1 : 192.168.3.1/24 - internal

Please how do I setup VPN, so I could reach 192.168.1.0 network from 192.168.3.0 ?

Thanx

This thread was automatically locked due to age.

Parents

0 squeeze over 23 years ago

http://docs.astaro.org/docs/vpn_howto.htm
Cancel
Vote Up 0 Vote Down

Cancel
0 Matt Siemens over 23 years ago in reply to squeeze

The NET to NET (Astaro to Astaro) portion of the VPN howto document mentioned above appears to be missing. Does anyone have a completed version of this document?

Thanks,

--Matt
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Matt Siemens over 23 years ago in reply to squeeze

The NET to NET (Astaro to Astaro) portion of the VPN howto document mentioned above appears to be missing. Does anyone have a completed version of this document?

Thanks,

--Matt
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Fazil over 23 years ago in reply to Matt Siemens

If you ever find out.. I'd like to know...

fazil@softhome.net

Thanks [:)]
Cancel
Vote Up 0 Vote Down

Cancel
0 Fazil over 23 years ago in reply to Fazil

Well, I finally got my IPsec tunnel working.. used the Astaro-->Cisco doc.. Ignore anything regarding the cisco stuff [:)]

So, basically.. I just set them both up EXACTLY the same.. with the IP address info changed depending on what I was using at each site.

Hope this helps!
Cancel
Vote Up 0 Vote Down

Cancel

Astaro Net-to-Net

Submitted a Tech Support Case lately from the Support Portal?