This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SSH Sentinel and Astaro

I am trying to configure a Win98 box using SSH Sentinel version 1.2.3 to connect to a Astaro firewall.

When I perform a probe the results say that the remote host of gateway was unsuccessful. The remote end does not respond to IKE requests.

Can someone post a step by step configuration for this configuration

Thanks

This thread was automatically locked due to age.

Parents

0 Polluxxx over 23 years ago

Did you read http://docs.astaro.org/docs/vpn_howto.htm?

kind regards
/polluxxx
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Polluxxx over 23 years ago

Did you read http://docs.astaro.org/docs/vpn_howto.htm?

kind regards
/polluxxx
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 who over 23 years ago in reply to Polluxxx

Make sure you are using 3DES as you encrytion algorithm for both IKE and IPSEC on SSH sentinel. It defaults to Rijndael. Also make sure you setup rule filter.

Thanks.
Cancel
Vote Up 0 Vote Down

Cancel

SSH Sentinel and Astaro

Submitted a Tech Support Case lately from the Support Portal?