This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Ping to internal network don't work

Hi all, I have set 2 Rules
1 PPTP-Pool->Any->LAN Allow
2 LAN->Any->PPTP-Pool Allow
but I can't form PPTP DialIn machine (W2K pro) to the internal Network. I get an IP from the Pool, for example 10.90.153.100 (Ping Ok) and add a route "192.168.1.0 mask 255.255.255.0 10.90.153.100". If I try to ping any internal IP I get a timout.

Maybe I have forget anything to configure, but I can't find it. Many thanks for you help.

This thread was automatically locked due to age.

0 ollion over 23 years ago

RD4,

try to switch on ICMP FORWARD in WebAdmin: PACKET FILTER/ICMP

regards
ollion

[ 15 February 2002: Message edited by: ollion ]
Cancel
Vote Up 0 Vote Down

Cancel
0 RD4 over 23 years ago in reply to ollion

thanks ollion,
but that's not the problem, because ICMP-Forward is allready enabled.

--
Ralph
Cancel
Vote Up 0 Vote Down

Cancel
0 ollion over 23 years ago in reply to RD4

RD4,

setting routes is not nescessary if you connect from a
Windows client, because the default route will be set
automatically to your dialup connection.
I just checked my setup, everything works fine.
Are the default routes set correctly on you LAN clients, pointing to the firewall?

regards
ollion
Cancel
Vote Up 0 Vote Down

Cancel