This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Replacing UTM

I am going to replace (buy new UTM) old UTM - Endpoint have been deployed to 10+ desktops.
Do I have to re-install endpoint software on each desktop to "link them" to new UTM?

This thread was automatically locked due to age.

0 BrucekConvergent over 10 years ago

No, as long as you restore the backup from the old unit to the new unit. The UTM-ID is saved in the configuration backup file, not tied to the actual hardware. If you create a new configuration from scratch on the new UTM, then yes, you would have to re-deploy.

CTO, Convergent Information Security Solutions, LLC

https://www.convergesecurity.com

Advice given as posted on this forum does not construe a support relationship or other relationship with Convergent Information Security Solutions, LLC or its subsidiaries. Use the advice given at your own risk.
Cancel
Vote Up 0 Vote Down

Cancel
0 krzychol over 10 years ago in reply to BrucekConvergent

Thank you.
Cancel
Vote Up 0 Vote Down

Cancel
0 Amodin over 10 years ago

So I just replaced my UTM, and brought it back up to the same version I had prior, and had a backup configuration file from the night before which included the Endpoint config, etc.

After re-applying the .abf file, Endpoint config was NOT applied up as advertised, so now I have no control on my Endpoint clients.

Only have four clients to re-install, but this is still annoying that things like this are not working correctly. [:@]

XG 19.5 GA 64-bit | Intel Xeon 4-core v3 1225 3.20Ghz
16GB Memory | 500GB SSD HDD | GB Ethernet x5
Cancel
Vote Up 0 Vote Down

Cancel

Replacing UTM

Submitted a Tech Support Case lately from the Support Portal?