Masquerading not working properly?

Question

Hi There, 
 
 I recently configured a new interface for a new vlan which is 10.70.0.1/28 and configured a Masquerading rule for this Network to use one of our public IP addresses. But it seems that the rule is not taking an effect. 
 I had 2 interfaces configured for public IP address and when I configure the new vlan (10.70.0.1/28) to publicIP1 it would show instead publicIP2. Any Ideas?

Paolo Lat · Accepted Answer

Hi Guys, 
 
 Thanks for the replies!! 
 
 I think the problem was there was already a multipath rule existing and I didn't consider that, so I had to create a new multipath rule for the new VLAN and that points out to the right public IP. 
 
 I inherited the firewall so I'm kinda confuse why he placed this kind of rules. I think I would only use this on extreme occasions, unless they're really important just for internal going out.