Hi, sorry, newbie question alert.
Set-up
UTM 9.502-4 running on "small" PC brick with 3 NICs (Eth0 is hardwired, Eth1 and 2 are USB <> Ethernet dongles)
Eth0 (Management NIC) has 192.168.10.250
Eth1 (ISP interface)
Eth2 (LAN interface) has 192.168.10.1
4 x "Out of the box" Firewall entries as defined by installation wizard
MASQ set to "LAN (Network) ==> ISP" (i.e. Eth2 ==> Eth1)
DHCP set against LAN interface (Range 192.168.10.3 to .50)
Test1
ISP connected to Eth1
Laptop (static IP) connected to LAN interface on Eth2
Result : Not able to connect to Internet
Test2
ISP connected to Eth1
Laptop (static IP) connected to Management interface on Eth0
Result : SUCCESS. Able to connect to Internet
Test3
ISP connected to Eth1
Laptop (static IP) connected to LAN interface (Eth2, DHCP removed from interface)
Result : Not able to connect to Internet
There (clearly) seems to be an "issue" with my config. When the Laptop is directly connected to the LAN interface (Eth2) it's UNABLE to route to the Internet however when connected to the Management NIC (Eth0) instead it finds its way out.
If I replace my Laptop with an R7000 (in AP mode using both hardcoded and dynamic IPs) to the LAN interface (Eth2) I get the same results as when my Laptop is connected -- obvious, but I checked.
Any thoughts/words of wisdom would be very much appreciated as I just can't see what is "not" allowing the routing of traffic to the ISP interface (Eth1) when I connect to the LAN interface (Eth2).
- Steve
This thread was automatically locked due to age.
