NAT

Question

how do i configure that allow user PC from 192.168.1.X/24 (without gateway) open browser and key in the 192.168.231/webapps , then it direct open the web application. 
 as i know using NAT but full nat ? 1:1 NAT

BAlfson · Accepted Answer

Hi, Dennis, and welcome to the UTM Community! 
 I'm not sure what your 1:1 NAT question is. Are you referring to the Cisco term 1:1 NAT or to the "1-to-1 NAT" which is used in the UTM to map one subnet to another? 
 You could do this with NAT or Webserver Protection. To do it with NAT, make a rule like 
 Full NAT 
 Traffic from: {Interface on eth0} (Network) Using: Web Surfing Going to: {Interface on eth0} (Address) 
 Change Source: {Interface on eth1} (Address) Change Destination: {192.168.32.107} 
 There are other ways to do this with NAT and routing, but they are more complicated. 
 Cheers - Bob