Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 10 replies
  • Subscribers 4 subscribers
  • Views 6250 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Routing

MichaelHinkle

I have a phone network with and subnet of 192.168.102.1 Which is a edgemax router. The UTM at site 1 has a primary subnet of 192.168.2.0. I also have set up a secondary interface on the UTM with 192.168.102.25. I then have that set up to go across our vpn. The UTM at site 2 is 192.168.12.1 and the phone network on ETH3 is 192.168.212.1. My phones at site 2 need to get to the 192.168.102.0 network but it has a default gatway of 192.168.102.1. Since the UTM is 192.168.102.25 I cannot get the traffic to flow. I can ping from site 1 to 2 OK, but Site 2 can not ping beyond the 192.168.102.25. I need to reach the gateway for the 102 network. Can yo help please..



This thread was automatically locked due to age.
Parents
  • 0

    Hi, Michael, and welcome to the UTM Community!

    Perhaps you could show a simple stick diagram with IPs and subnets noted.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0

    Hi, Michael, and welcome to the UTM Community!

    Perhaps you could show a simple stick diagram with IPs and subnets noted.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
  • 0 in reply to BAlfson

    Hey Michael, I'm with Bob pictures are good, done in crayon even better..anyway it sounds like you may just need a route added to the Edgmax that points to 192.168.102.25 as it's next hop. Something like "ip route 192.168.212.0 255.255.255.0 192.168.102.25" Then making sure the VPN is configured with the necessary interesting traffic. Same on the other side only inverse for the phone subnets, just "connect the dots" if you will.

    cooper

  • 0 in reply to ToddCooper

    I left out the fact that on the UTM at 102.25 you need a static route statement for "network 192.168.102.0 255.255.255.0 (next hop 192.168.102.1" to get back inside to the phones.

Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?

Unfiltered HTML