Good Morning, Evening or Afternoon I'm playing around with UTM9 for about a week now but I didn't figure out how to allow my synology diskstation to access the internet. I wanted to allow: the system to check for updates and download them, the package manager to do the same, the CloudStation to sync with DropBox, google drive, onedrive, and pyLoad to download files. I thought it would be enough the create the following DNAT-rule: For traffic from: Any Using service: type: TCP destination port: 5000,5001,6690 source port: 1:65535 going to: WAN (Address) Change the destination to: synology(host), specified with static IPv4 and MAC address Automatic firewall rule: check What am I missing that it doesn't work? Furthermore: pyLoad itself is ultra slow - not the downloadspeed (as I am not yet able to test this) - but just switching tabs withing pyLoad takes ages. What could be the reason for this behaviour? It's not that slow if access without the utm. Thank you very much in advance for every advice.

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Synology has no access to internet (e.g. system update or CloudStation)

Good Morning, Evening or Afternoon

I'm playing around with UTM9 for about a week now but I didn't figure out how to allow my synology diskstation to access the internet. I wanted to allow: the system to check for updates and download them, the package manager to do the same, the CloudStation to sync with DropBox, google drive, onedrive, and pyLoad to download files.

I thought it would be enough the create the following DNAT-rule:

For traffic from: Any
Using service:
- type: TCP
- destination port: 5000,5001,6690
- source port: 1:65535
going to: WAN (Address)
Change the destination to: synology(host), specified with static IPv4 and MAC address
Automatic firewall rule: check

What am I missing that it doesn't work?

Furthermore: pyLoad itself is ultra slow - not the downloadspeed (as I am not yet able to test this) - but just switching tabs withing pyLoad takes ages. What could be the reason for this behaviour? It's not that slow if access without the utm.

Thank you very much in advance for every advice.

This thread was automatically locked due to age.

Parents

0 UThomas over 8 years ago

to the first question. You need DNAT rules if you want you to connect to the synology from the internet.

The synology should using HTTP(s) to check/download firmware. Do you use the web proxy or do you have an firewall rule to allow traffic from internal network to port 80 and 443 ?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 UThomas over 8 years ago

to the first question. You need DNAT rules if you want you to connect to the synology from the internet.

The synology should using HTTP(s) to check/download firmware. Do you use the web proxy or do you have an firewall rule to allow traffic from internal network to port 80 and 443 ?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Synology has no access to internet (e.g. system update or CloudStation)

Submitted a Tech Support Case lately from the Support Portal?