This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NAT rule and RED device

We have a location set up with a RED device. On that location we also have a webserver we'd like to forward webrequests from Bitbucket to. I found a guide saying I needed to use a FULL NAT rule for this, but still it doesnt work.

I have screenshots here:

Anyone know how to fix this ?

This thread was automatically locked due to age.

0 sachingurung over 8 years ago

Hi,

Please post the link for the guide you referred. Where is the Server located and from where are you looking to access the server? What is Bitbucket and how will the traffic request arrive on UTM? Are you trying to route the traffic from Bitbucket through RED tunnel on the server?

If full NAT is the solution to this then take care of these points. In the full NAT policy, make sure that the request will only require HTTP proxy port and no other. Try configure ANY in place of HTTP proxy to test. Finally, make sure that the Going to: must be External (WAN Address).

Thanks

Sachin Gurung
Team Lead | Sophos Technical Support
Knowledge Base | @SophosSupport | Video tutorials
Remember to like a post. If a post (on a question thread) solves your question use the 'This helped me' link.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 8 years ago

Einar, the first thing I would suspect would be that the definition "Jenkins mast..." violates #3 in Rulz - was that it?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

NAT rule and RED device

Submitted a Tech Support Case lately from the Support Portal?