This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

raspberry pi homekit bridge access

I have a raspberry pi acting as a homekit bridge for a few home automation devices. Is there any way to configure astaro to allow me to access the devices away from home?

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

Setup DNATs for each of the devices or use one of the Remote Access VPN methods to connect to the UTM, then from there you can reach your devices.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 9 years ago

Setup DNATs for each of the devices or use one of the Remote Access VPN methods to connect to the UTM, then from there you can reach your devices.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 gdavis17 over 9 years ago in reply to Scott_Klassen

Thank you for the reply. I currently have L2TP over IPSEC and Cisco VPN setup for IOS devices. While connected to my VPN I am correctly served my Astaro DNS sever, but I cannot access my Raspberry Pi homekit bridge. I have tried to create a DNAT rule for port 51826, but it still isn't working. I would like to have access to the Raspberry Pi homekit bridge because it controls my garage door. VPN access would be ideal for security, but I can't figure out what is stopping it. Does any one have any ideas? Thanks a lot.
Cancel
Vote Up 0 Vote Down

Cancel