This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Opening Port to Public IP

I am trying to make my camera server accessible from the internet. I have followed all of the port forwarding guides but I must have missed something. If I try to access the server internally on the port I opened "8081" works fine. Anything from the outside no luck. I have my dnat rule setup as this "Traffic From-Any" to "Using Service-8081" to "Going to-External(WAN Address)". Actions are "Change the destination to-Camera Server" to "and the service to-8081". I have checked the automatic firewall rule as well. Any help is much appreciated thank you.

This thread was automatically locked due to age.

Parents

0 eholyst over 9 years ago

Here is a screenshot of the dnat policy.
[url=http://postimg.org/image/5v8qkzvvj/][img]s11.postimg.org/.../url]

let me know what other would be helpful.

That is correct the utm is directly connected to the internet. I never saw anything in the firewall log when I tried to enter via the public IP.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 eholyst over 9 years ago

Here is a screenshot of the dnat policy.
[url=http://postimg.org/image/5v8qkzvvj/][img]s11.postimg.org/.../url]

let me know what other would be helpful.

That is correct the utm is directly connected to the internet. I never saw anything in the firewall log when I tried to enter via the public IP.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 khardeveld over 9 years ago in reply to eholyst

In the screenshot you provided: If you click on 'advanced', then enable 'Log initial packets'
Now if you check your firewall logs, do you see DNAT rule 4 mentioned?

If not, this would indicate that the traffic does not get to your UTM
Cancel
Vote Up 0 Vote Down

Cancel