Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 9 replies
  • Subscribers 2 subscribers
  • Views 20948 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

None of my NAT Rules are working Sophos Home UTM

lamocorp
Ok I  have a few Nat Rules on my Sophos Home UTM latest version fully updates installed as a Hyper-V VM and only my RDP NAT Rule seems to be working. I have the DNAT  Rules below and the second rule works but not the third. My Network definitions have the interface set to Any so its not that being the issue. Thanks.


    EditDeleteClone
2 DNAT
Traffic selector: Any → SSH → ***.***.com
Destination translation: ***-xx2 Microsoft Remote Desktop (RDP)
Automatic Firewall rule:
Initial packets are logged:
 
EditDeleteClone
3 DNAT
Traffic selector: FlowRoute Servers → FreePBX Services → ***.***x.com
Destination translation: ***.xx2
Automatic Firewall rule:
Initial packets are logged:


This thread was automatically locked due to age.
Parents
  • 0
    Additional WAN IPs NEED to be set at Interfaces & Routing > Interfaces > Additional Addresses individually and enabled to work.  Then you would set the Going To Matching condition in your DNAT to the additional address (address) object, just like you did with the primary.
Reply
  • 0
    Additional WAN IPs NEED to be set at Interfaces & Routing > Interfaces > Additional Addresses individually and enabled to work.  Then you would set the Going To Matching condition in your DNAT to the additional address (address) object, just like you did with the primary.
Children
No Data