Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 2 subscribers
  • Views 924 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Trafic Shaping

EricFrancoeur
I've swap my Cisco 1941K for an SG330.
I'm on a 10M/10M dedicated Fiber line.

My upload before with speedtest.net was avg 8.83Mbps now with SG330 it can't get passed 2 Mbps....

I know it's a traffic shaping and port issue, because at our other location I've installed an 5M/5M, and I had to change the BWM down to  5Mbps and FORCE the port to 10M Duplex

I think I've found where to set up the 10Mbps... but not where to force the port to 10M Duplex

Anyone knows how to force it?


This thread was automatically locked due to age.
  • 0
    On the 'Hardware' tab of 'Interfaces & Routing >> Interfaces', Edit the NIC, un-check 'Auto negotiation' and make your speed selection.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • 0
    Once again Bob you are my hero!!!

    I hope Sophos pays you a lot of money for this... If I'm buying a Sophos instead of a Watchguard, it's mainly because of you... well because I can make it do what I want it to do XD 

    Thanks
Cookie Information Banner