This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Use additionl address as outgoing for one server?

Hi,

I have 5 public IP's and at the moment it all comes out on one IP but i need to have the return traffic for one server to return on the same incomming IP which is one of the 5. I tried SNAT without success, and Masquerade NAT.

What do i need to do? It has to be from the one server not any others. I can either filter it by service or allow all traffic as long as its only from the one server.

Thanks

This thread was automatically locked due to age.

Parents

0 vilic over 10 years ago

SNAT:

For traffic from: SERVER
Using service: ANY
Going to: Internet IPV4

Change the source to: Interface Additional Address object
Cancel
Vote Up 0 Vote Down

Cancel
0 JohnKenny over 10 years ago in reply to vilic

So I made some changes: -

I added a new Masq NAT rule at priority 1: -

SERVER - External interface, using address ALT EXT IP

I also added an additional SNAT rule at priority 1: -

SERVER - Any traffic - Any Address
Change source to - ALT EXT IP

But I went to whatsmyip.org on the server in question and it still says its using the ORIGINAL IP

What am I doing wrong, should this work?

Thanks

JK

JK

CompKickers
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 JohnKenny over 10 years ago in reply to vilic

So I made some changes: -

I added a new Masq NAT rule at priority 1: -

SERVER - External interface, using address ALT EXT IP

I also added an additional SNAT rule at priority 1: -

SERVER - Any traffic - Any Address
Change source to - ALT EXT IP

But I went to whatsmyip.org on the server in question and it still says its using the ORIGINAL IP

What am I doing wrong, should this work?

Thanks

JK

JK

CompKickers
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data