This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Allow All to another firewall

Hi,
I have a block of 8 public ip's. One of those ip's is for my test network which is protected by a Cisco ASA.
From the Sophos UTM, I can DNAT to this ASA (172.31.255.2/30) but DNAT only allows me to select certain services eg https to be natted to the ASA ie 2nd public ip (https) > ASA (https)
I would like all services to be nat'd or routed to the ASA ie 2nd public ip (ALL) > ASA (ALL)

There's obviously a way to do this on the UTM but I can't seem to find it.


This thread was automatically locked due to age.
Parents
  • Louis, check #5 in Rulz.  Was that it?

    Cheers - Bob
  • Hi,
    thank you, that did the trick. I tried to edit the rule first ie delete the "any services" but to no avail.
    Once I deleted the rule and started afresh, it allowed me to put the DNAT rule in. You simply don't touch the services at all otherwise you have to start again.

    Thank you for your assistance with this. Much appreciated.

    And on a seperate note, to Sophos (or Astaro), in all my years of experience with firewalls etc, from various flavours of Linux, BSD's & Cisco's etc, this particular product is probably the best out the lot of them with regards to functionality and ease of use.
Reply
  • Hi,
    thank you, that did the trick. I tried to edit the rule first ie delete the "any services" but to no avail.
    Once I deleted the rule and started afresh, it allowed me to put the DNAT rule in. You simply don't touch the services at all otherwise you have to start again.

    Thank you for your assistance with this. Much appreciated.

    And on a seperate note, to Sophos (or Astaro), in all my years of experience with firewalls etc, from various flavours of Linux, BSD's & Cisco's etc, this particular product is probably the best out the lot of them with regards to functionality and ease of use.
Children
No Data