This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Connecting RDC To External Address BY IP ONLY

I have a requirement to connect to an external Remote Desktop Console (RDC) via an IP address and non-std port (5588). I can perform a successful
NSLOOKUP from the UTM to the external address. When attempting an NSLOOKUP from my machine it goes to the UTM then dies, but that is most likely because of the ICMP settings.

I have monitored the logs for everything I can think of and cannot find the drop.

Firewall Rule: Internal VLANS > any> Internet IPV4
DNS Set up per recommendations on this forum.

What do I need to configure to allow this traffic

This thread was automatically locked due to age.

Parents

0 DarkKnight93 over 10 years ago

So your nslookup from Client Fails? Which address to you want to resolve - your own external address (e.g. DynDNS or static dns)?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 DarkKnight93 over 10 years ago

So your nslookup from Client Fails? Which address to you want to resolve - your own external address (e.g. DynDNS or static dns)?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data