This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Multipath rules problem in firmware version 9.309-3

I have serious problem with firmware version 9.309-3. I had configure multipath rules for my 3 WAN Interface for distribute internet bandwidth to 18 VLAN interface and its works perfectly.
After update firmware version 9.309-3, multipath rules not working perfectly (mean Two different PC in single VLAN interface used two different WAN interface)

Anybody face this issue? I m in big trouble right now. Need help urgently... Its my pleasure anybody resolve my problem.

Thanks.

Amrish

This thread was automatically locked due to age.

Parents

0 Marc M over 10 years ago

Hi Amrish as I post in the other threat the only way to solve it was create a Policy Route

Route Type = Interface route
Source Interface = Uplink Interfaces
Source Network = Any
Service = Web Surfing
Destination Network = Internet IPv4
Target Interface = WAN03

Its mean that no matter where the ASG send the traffic the policy route bring the connection to go out from WAN03

Its strange but I try everything in Multipath rules but is like Multipath Rules are totally ignored no matter what you do.

thx.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Marc M over 10 years ago

Hi Amrish as I post in the other threat the only way to solve it was create a Policy Route

Route Type = Interface route
Source Interface = Uplink Interfaces
Source Network = Any
Service = Web Surfing
Destination Network = Internet IPv4
Target Interface = WAN03

Its mean that no matter where the ASG send the traffic the policy route bring the connection to go out from WAN03

Its strange but I try everything in Multipath rules but is like Multipath Rules are totally ignored no matter what you do.

thx.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data