This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bridge two Sophos together?

We have two SG210's and I want them to share WAN connections if their main WAN goes down.  I know this works great with just one SG210 with two WAN's using uplink balancing but is it possible to share same WAN between two different SG210's? 

SG210-1
eth1 - LAN 1
eth2 - WAN1
eth4 - LAN 2


SG210-2
eth1 - LAN 1
eth2 - WAN1

Dave


This thread was automatically locked due to age.
Parents
  • You are probably looking to set up an Active/Passive failover setup, not a cluster.  That is supported with the BasicGuard subscription.

    Your other option is to learn more about OSPF and possibly get a bunch more equipment and set up dynamic routing rules, which is probably outside of the scope of what you need to do.

    Barry's suggestion is almost certainly what you want, connect WAN1 to switch 1, connect WAN2 to switch 2, connect one SG 210 and set it up for dual WAN.  Then add the second unit with the HA ports connected and as long as you did it right, automagic HA/failover between WAN connections and SG 210 units.
Reply
  • You are probably looking to set up an Active/Passive failover setup, not a cluster.  That is supported with the BasicGuard subscription.

    Your other option is to learn more about OSPF and possibly get a bunch more equipment and set up dynamic routing rules, which is probably outside of the scope of what you need to do.

    Barry's suggestion is almost certainly what you want, connect WAN1 to switch 1, connect WAN2 to switch 2, connect one SG 210 and set it up for dual WAN.  Then add the second unit with the HA ports connected and as long as you did it right, automagic HA/failover between WAN connections and SG 210 units.
Children
No Data