This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unable To Reach Additional IP Range On Interface

We have a WAN interface with a static IP of 10.0.0.1. The ISP modem only has one LAN port, so when they assigned the additional range of 10.0.1.1/29, we added that range as an additional address to the WAN interface of 10.0.0.1

In doing so, we have the WAN interface for the ISP with two addresses (both reachable) - 10.0.0.1 and 10.0.1.2. We have a third party backup router bridged to this WAN interface for their VPN and their IP address is 10.0.1.3 with their gateway set to 10.0.1.2.

From our system, we can ping to 10.0.1.2 but cannot reach 10.0.1.3. However, if we log into the UTM, I can ping 10.0.1.3. What am I missing? [:S]

We have a FW rule of Any > Any > Additional Address Range and all pings are allowed. Any suggestions on where I should look?

This thread was automatically locked due to age.

Parents

0 BAlfson over 10 years ago

I see you have a bridge, but I still don't know what addresses are where or where the device is from which you're trying to reach 24.1.1.2.

Cheers- Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 CWanamaker over 10 years ago in reply to BAlfson

Bob,

Everything we're dealing with is on the public side. And if I try to ping/trace/ssh 24.1.1.2 from anywhere, it doesn't work. I just need to be able to access 24.1.1.2 from the internet and can't
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 CWanamaker over 10 years ago in reply to BAlfson

Bob,

Everything we're dealing with is on the public side. And if I try to ping/trace/ssh 24.1.1.2 from anywhere, it doesn't work. I just need to be able to access 24.1.1.2 from the internet and can't
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data