Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 13 replies
  • Subscribers 2 subscribers
  • Views 2862 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DNATting port groups and IPs

Mast_01
Hello,
simple quesiton, i need to dnat several ports to several internals IPs, is there a way to avoid having to make one DNAT per service/destination?.
in this specific case is for IP cam monitoring, each ip cam uses 3 fixed ports.
since the public ip is the same, alt ports are used for every cam.

this means i have to make 3 DNAT rules and 3 source services PER camera, very time-consuming and a mess of rules/definitions.
since the ports used are consecutive, ¿is there a way to simplify this mess?


This thread was automatically locked due to age.
Parents
  • 0
    Well after some digging i've found out that those internal IPs where NOT IP cams, but in fact DVRs, +10 of them because of the sheer ammount of cams distributed all over the place. And there's no chance of unifying them into one DVR(wiring, etc)
    so there's nothing to be done...
Reply
  • 0
    Well after some digging i've found out that those internal IPs where NOT IP cams, but in fact DVRs, +10 of them because of the sheer ammount of cams distributed all over the place. And there's no chance of unifying them into one DVR(wiring, etc)
    so there's nothing to be done...
Children
No Data