Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 19 replies
  • Subscribers 2 subscribers
  • Views 43964 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Static route

Azwan
Hi Everyone,

Does any know or have done configure static route for incoming 0.0.0.0 --> Internal from GUI or command without need to define every segment network that required access the internal network behind Sophos UTM.

Below is Sophos UTM deployment that I plan for customer, appreciate if you guys can advice or guide me to solve this issue. Thanks[:S]

Sophos UTM Deployment Network Information
1. HQ to Branch connection :
    -Telco lease line 512k
 
2.HQ (Palo Alto):
   -HQ Firewall  (WAN IP 10.81.201.30 GW 10.81.201.10)
   -Static route (Interface Route 0.0.0.0 GW10.81.201.10)
 
3.Branch (Sophos UTM220):
  -Branch Firewall (External IP 10.61.201.30 GW 10.61.201.10)(Internal IP 10.61.1.10)
  -Masquerading NAT (Internal -> External)
  -Firewall rule (ANY-ANY)


This thread was automatically locked due to age.
Parents
  • 0
    Hi, incoming traffic (destined for your Internal network, via the 10.61.201.10 gateway) should be routed automatically.

    If you have additional internal networks at the Branch, which are not defined on the UTM, you may need to create static routes for them (via the webadmin GUI).

    Am I missing something?

    Barry
Reply
  • 0
    Hi, incoming traffic (destined for your Internal network, via the 10.61.201.10 gateway) should be routed automatically.

    If you have additional internal networks at the Branch, which are not defined on the UTM, you may need to create static routes for them (via the webadmin GUI).

    Am I missing something?

    Barry
Children