This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPS - Performance Problem

Hi guys,

I have a little performance issue and I hope anyone have an idea , how I can go on.

At this moment, it occurres only @home
Software Appliance - Version: 9.101-12

Internet - cable modem bandwidth100-120mbit/s - UTM
With the version 9.0, I have a throughput of 80-90mbit/s.

Since the update to 9.1, the throughput is only 20-30mbit/s (same config, same system).
If I disable the IPS, I get great values again 100-110mbit/s.
In the IPS configuration I select only the systems I use. I active the IPS and after seconds... I have the bad values again.

This is only from WAN to LAN. From LAN to DMZ, everything is all right.

Nice greetings

This thread was automatically locked due to age.

Parents

0 BarryG over 12 years ago

Hi,
All of you using VMs:

1. which VM hypervisor (ESXi or KVM or ?)

2. which NIC drivers are you using in the Astaro VM?
Note that the 'flexible' drivers have severe performance problems; the VMxNet or e1000 drivers are recommended.

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 FrancWest over 12 years ago in reply to BarryG

Hi,
All of you using VMs:

1. which VM hypervisor (ESXi or KVM or ?)

2. which NIC drivers are you using in the Astaro VM?
Note that the 'flexible' drivers have severe performance problems; the VMxNet or e1000 drivers are recommended.

Barry

I'm using ESXi 5.1. Nic drivers used are VMXNET 3.

Franc.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 FrancWest over 12 years ago in reply to BarryG

Hi,
All of you using VMs:

1. which VM hypervisor (ESXi or KVM or ?)

2. which NIC drivers are you using in the Astaro VM?
Note that the 'flexible' drivers have severe performance problems; the VMxNet or e1000 drivers are recommended.

Barry

I'm using ESXi 5.1. Nic drivers used are VMXNET 3.

Franc.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data