Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 13 replies
  • Subscribers 2 subscribers
  • Views 4255 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unable to setup NAT rule

xp3000
Hi,

I'm trying to setup a NAT rule to allow our HQ to connect to the UTM9 firewall on external interface on our public ip and port 8787 and then forward this to an internal webserver running on port 8787.

i've attached a couple of screenshots to see what i'm doing wrong, also on our external interface we're getting a error in UTM GUI.


This thread was automatically locked due to age.
Parents
  • 0
    These rules show that you are using http as the service? I believe that's for testing purposes right?

    However I was talking about the definitions - the Setting of the "HQ IP" and the "servive". Just double click them.

    Sorry if I'm asking the obvious but the Firewall doesn't recognise the traffic which in almost all cases is because of a wrongly set rule/definition or a typo of some kind.
Reply
  • 0
    These rules show that you are using http as the service? I believe that's for testing purposes right?

    However I was talking about the definitions - the Setting of the "HQ IP" and the "servive". Just double click them.

    Sorry if I'm asking the obvious but the Firewall doesn't recognise the traffic which in almost all cases is because of a wrongly set rule/definition or a typo of some kind.
Children
No Data