This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

unable to connect to SUM4.

I actually had this issue popup using ACC3.  My Sophos v9 is dropping 4433(which is the acc protocol) by default even though i have it set to be open.  Sophos 9 will simply not allow that port tob e open and it'sd a bit frustrating..[:)]


This thread was automatically locked due to age.
Parents
  • ok i've verified that it is sum4 not looking for the acc protocol on any port i give it..any ideas?
  • Check your NAT / packet filter rules, works fine here.

    Make sure you have SUM configured to allow access from the hosts that are connecting to it; I find folks forget about this setting sometimes.
  • Check your NAT / packet filter rules, works fine here.

    Make sure you have SUM configured to allow access from the hosts that are connecting to it; I find folks forget about this setting sometimes.


    the interesting thing is my rule hasn't changed in years:
    DNAT
    Traffic selector: Any → Astaro Command Center (ACC) → External (WAN) (Address)
    Destination translation: ACC
    Automatic Firewall rule:
    Initial packets are logged:
    the port def for the Astaro Command Center is 4433.
Reply
  • Check your NAT / packet filter rules, works fine here.

    Make sure you have SUM configured to allow access from the hosts that are connecting to it; I find folks forget about this setting sometimes.


    the interesting thing is my rule hasn't changed in years:
    DNAT
    Traffic selector: Any → Astaro Command Center (ACC) → External (WAN) (Address)
    Destination translation: ACC
    Automatic Firewall rule:
    Initial packets are logged:
    the port def for the Astaro Command Center is 4433.
Children
No Data