This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Qos - with ipsec vpn tunnel

Hi,
we have an 9.x sw appliance with 2x ipsec vpn tunnels configured to our remote branches.
In one remote branch we have a PBX connected through a sip trunk to the main office pbx.
We have an ADSL connection (20 down, 2 up).
We plan to change this link to a HDSL simmetric line but until then I need to priorize the voip and vpn traffic because the uplink bandwith is heavily used.
I read the manual and it's clear how to configure qos (1-define interface download/upload setting, 2-define traffic selectors and 3-define bandwith pools) but I did not understand if:

1) is it possible to priorize the sip traffic INSIDE the vpn tunnel?
2) is it possible to priorize the entire vpn tunnel that transport the sip traffic VS the one that do not have it?

Thanks for your help.


This thread was automatically locked due to age.
Parents
  • If the VPNs have the same endpoints (IPs), you can't differentiate the traffic.  Your traffic selector on each side would look like 'External [VoIP] (Address) -> IPsec -> Remote VoIP Endpoint' where the "Remote VoIP Endpoint" IP would be the "External [VoIP] (Address)" on the other side.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • If the VPNs have the same endpoints (IPs), you can't differentiate the traffic.  Your traffic selector on each side would look like 'External [VoIP] (Address) -> IPsec -> Remote VoIP Endpoint' where the "Remote VoIP Endpoint" IP would be the "External [VoIP] (Address)" on the other side.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data