This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[Answered]All "user networks" are unresolved

Hello
in some cases I would like to use "user networks" to allow certain users via firewall rule to do certain things.

The problem is that all user networks (known IP addresses of user x) are unresolved.

Users are synced from AD

Any ideas, why user networks aren't working?

Thanks for any advice [:)]

Best regards
chas0rde

This thread was automatically locked due to age.

Parents

0 BAlfson over 12 years ago

network traffic by, for example, creating firewall rules based on user networks or group networks.

I agree, it's not working in V8.309, either. The "sbold (User Network)" object still was unresolved two hours after the below:

2013:05:01-10:36:47 astaro aua[4187]: id="3006" severity="info" sys="System" sub="auth" name="Trying 10.x.y.7 (adirectory)"
2013:05:01-10:36:47 astaro aua[4187]: id="3004" severity="info" sys="System" sub="auth" name="Authentication successful" srcip="10.x.y.64" user="sbold" caller="endpoint" engine="adirectory"

Cheers - Bob

Reply

0 BAlfson over 12 years ago

network traffic by, for example, creating firewall rules based on user networks or group networks.

I agree, it's not working in V8.309, either. The "sbold (User Network)" object still was unresolved two hours after the below:

2013:05:01-10:36:47 astaro aua[4187]: id="3006" severity="info" sys="System" sub="auth" name="Trying 10.x.y.7 (adirectory)"
2013:05:01-10:36:47 astaro aua[4187]: id="3004" severity="info" sys="System" sub="auth" name="Authentication successful" srcip="10.x.y.64" user="sbold" caller="endpoint" engine="adirectory"

Cheers - Bob

Children

No Data