This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Multipath and Site to Site VPN

I've got a question about Multipath on Astaro 220

Main Site connected with two WAN connections (named FB and SLink),  all HTTP traffic is going out of the SLink connection.

Today I installed another astaro220 in a remote Site. That Site has one wan connection and is Site to Site vPN to the main Site through the SLink connection. That vPN is up but I can only reach HTTP servers in the remote Site from the main Site.  No windows network shares,  etc. It's so bizarre.  I have automatic rules turned on for both sides of the VPN

If anyone has any ideas,  I would greatly appreciate it.

This thread was automatically locked due to age.

Parents

0 Hallowach2 over 13 years ago

I think this is a display error. I bet you changend the example multipath rules and did not edit the comment. The dark (fat) black part shows the real setting and the lighter part the descriptive comment.

But if these are your MP rules your problem gets clear.

Try changing the rules from any-websurfing-any->interface to [some internal net]-websurfing-[internet]->interface and see if that changes something.

Btw. how is the scheduler set up (in Uplink Balancing -> the 'tool' symbol)

Regards
Manfred
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Hallowach2 over 13 years ago

I think this is a display error. I bet you changend the example multipath rules and did not edit the comment. The dark (fat) black part shows the real setting and the lighter part the descriptive comment.

But if these are your MP rules your problem gets clear.

Try changing the rules from any-websurfing-any->interface to [some internal net]-websurfing-[internet]->interface and see if that changes something.

Btw. how is the scheduler set up (in Uplink Balancing -> the 'tool' symbol)

Regards
Manfred
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data