This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reject All Rule?

Hello,
I was under the impression that e rule like this would effectively block all traffic??

Internal NetWork
Any
Any
Reject

Reject Rule.png.png

But as you can see the interfaces keep showing traffic!

Trafic With Reject Rule in Place.png.png

Is the rule incorrect or its something else ??

If the rule is wrong which parameters should I use to prevent all traffic from passing, and it shows no traffic (On the external interface the one showing 1 Mbit with the rule in place)

Thanks

This thread was automatically locked due to age.

Parents

0 vader9000 over 13 years ago

Thanks Balfson,
Apparently my backups have the same problem.

But if I understand if I disable web filter it should tell if the problem is there
Correct?
Cancel
Vote Up 0 Vote Down

Cancel
0 BrucekConvergent over 13 years ago in reply to vader9000

what does iftop -i ethx (where x is the interface you are seeing traffic on) show you? You would need to run this from the Console logged on as Root. Entering the letter 'q' will exit.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BrucekConvergent over 13 years ago in reply to vader9000

what does iftop -i ethx (where x is the interface you are seeing traffic on) show you? You would need to run this from the Console logged on as Root. Entering the letter 'q' will exit.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data