This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Simple Network Configuration Still Unable To Browse

Hi All,

I have a simple configuration setup 3 nics, configured as trusted, untrusted and dmz. Trusted and Untrusted configured fine and I'm able to browse the web with no problems at all. However, the DMZ interface is the tricky part. It will be connected to my linksys wireless router. So my config with this is as follows:

Trusted Interface - 10.x.x.x
Untrusted - Internet
DMZ - 172.x.x.x

I followed the configuration from:

https://community.sophos.com/products/unified-threat-management/astaroorg/f/53/t/32694

However, i'm still unable to browse and unable to access the DMZ from the Trusted interface. I have masquerade rules and a PF rule allowing the DMZ to any.... And i'm plugged into a LAN port on the linksys wireless router. 

Any Help is greatly appreciated.


This thread was automatically locked due to age.
Parents
  • If you connect with a cable to the LinkSys, do you get an IP in the "Internal (Network)" of Astaro?

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • No sir, not to the internal. the dmz has a 172.x.x.x address. And from my reading, I had configured the Astaro to handle the DHCP, so when I connect wirelessly I pull a 172.x.x.x address but i'm unable to browse the internet.
Reply
  • No sir, not to the internal. the dmz has a 172.x.x.x address. And from my reading, I had configured the Astaro to handle the DHCP, so when I connect wirelessly I pull a 172.x.x.x address but i'm unable to browse the internet.
Children
No Data