This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Dnat

Hi folks,

I´ve been receiving a default drop when I try to send a packet to IP address 172.29.103.9 port 5040.

I want to create a DNAT where network 172.10.4.0 uses IP address 192.168.131.71....

Could anyone help me with some hints ??

Thanks....

This thread was automatically locked due to age.

Parents

0 BAlfson over 13 years ago

I assume that NG_Redes_Ancon is the definition with IP 172.10.4.121 and that it is outside your network. Edit it to be sure that it is set to 'Interface: >'.

First, edit the "IPBanco_Gerenal" Additional Address to 'Address: 172.29.103.9'.

Next change the Host definition "Banco_General_Extremo" to 'Address: 192.168.131.71' with 'Interface: >'.

Finally, change your DNAT to:
Traffic Source: NG_Redes_Ancon
Traffic Service: Any
Traffic Destination: Telecarrier_Banco_General [IPBanco_Gerenal] (Address)

NAT mode: DNAT (Destination)

Destination: Banco_General_Extremo
Destination Service: {leave blank since not changing!}

Automatic packet filter rule: {Checked}

Is it working now?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 13 years ago

I assume that NG_Redes_Ancon is the definition with IP 172.10.4.121 and that it is outside your network. Edit it to be sure that it is set to 'Interface: >'.

First, edit the "IPBanco_Gerenal" Additional Address to 'Address: 172.29.103.9'.

Next change the Host definition "Banco_General_Extremo" to 'Address: 192.168.131.71' with 'Interface: >'.

Finally, change your DNAT to:
Traffic Source: NG_Redes_Ancon
Traffic Service: Any
Traffic Destination: Telecarrier_Banco_General [IPBanco_Gerenal] (Address)

NAT mode: DNAT (Destination)

Destination: Banco_General_Extremo
Destination Service: {leave blank since not changing!}

Automatic packet filter rule: {Checked}

Is it working now?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data