This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Non-Astaro Wireless Access Point

I have put a wireless modem/router onto the LAN (only using the LAN interface) and configured it as an access point. Firewall, ACLs, IPS are all turned off. I can connect wirelessly and get on the internet for about 10 minutes before the internet connection times out. I see on the astaro dashboard that the internet facing interface traffic increases when this occurs. I have tried disabling the astaro IPS, port scanning and rebooting the WAP as well as the astaro box to no avail. I have turned off the wireless card and rejoined the SSID, tried plugging into the wired LAN with the same result. The only thing that restores normlity is to unplug the LAN port of the WAP, then I can get onto the internet again. The astaro internet interface traffic reduces (corresponding with the LEDs on the actual internet modem).

My question is: although this is not an astaro WAP, has anyone seen this behavious before? I can get about 10 minutes whith the WAP connected and then internet activity is cut off (even pinging from the webmin console fails). Any pointers and troubleshooting steps would be appreciated, thanks.

I'm using the Astaro virtual appliance v7 running on vmware esxi
[:S]
regards,
Murray


This thread was automatically locked due to age.
Parents
  • Hi, Murray, and welcome to the User BB!

    What do you see on the WebAdmin dashboard when this happens?  In in-bound or out-bound traffic flooding the pipe?  Is the Astaro CPU or memory pegged?

    Cheers - Bob
Reply
  • Hi, Murray, and welcome to the User BB!

    What do you see on the WebAdmin dashboard when this happens?  In in-bound or out-bound traffic flooding the pipe?  Is the Astaro CPU or memory pegged?

    Cheers - Bob
Children
  • murrayvr,

    I am looking to do the same thing but I am in a little different boat. I was wondering if maybe we can get this working together. I am running the V8 Gateway (Home Use) and I was looking to connect my DDWRT flashed router to the network but allow Astaro Wireless to manage the connections. My thought was to create a network bridge but im still unsure the proper method.

    Do you or anyone else have any suggestions or have gotten this working?