This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

FreeSwitch setup With ASG

Good evening to all

I just discovered this great soft ware. I am long time PFsense user.

my challenge is to setup rules for the following services. on ASG V8

SSH (22)
FTP (21)
HTTP & HTTPS (80 & 443)

lastly Voip service sith FreeSwitch
-SIP (5060-5090) UDP
-RTP (16384-32768) UDP

there are several Polycom phones both internal and external

network is extremely simple but with a lot of endpoints

Cable Modem (static IP) --> Astaro (ASG) --> Switch --> Endpoints

My internal network is
192.168.2.0/24

the router is at 192.168.2.10

Please give me specific instructions on how to set this up.
I have been at this for hours without any real success; voice issues due to NAT.

Help

very new

This thread was automatically locked due to age.

Parents

0 kiwoneka over 14 years ago

How I got it all working PART 2

How I set the DNAT rules (I had a hard time with is; I just did not get it)
I do now [:)]

Disabled the VoIP Proxy (I just could not get it to work)
I also did not want to use a proxy; so I disabled it.

I enable the FTP proxy (my phones update using ftp)

I hope these help some else.
The support here has been amazing, and very very fast.
Extremely knowledgeable people helping.

Now i am going to setup TLS for all my phones.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 kiwoneka over 14 years ago

How I got it all working PART 2

How I set the DNAT rules (I had a hard time with is; I just did not get it)
I do now [:)]

Disabled the VoIP Proxy (I just could not get it to work)
I also did not want to use a proxy; so I disabled it.

I enable the FTP proxy (my phones update using ftp)

I hope these help some else.
The support here has been amazing, and very very fast.
Extremely knowledgeable people helping.

Now i am going to setup TLS for all my phones.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data