So I have an internal server that uses a different default gateway. After searching the forums a bit I found a post by Mr. Daniel on that if the device inside the network is not using the astaro as the default gateway then you will need to setup a full nat. The goal here is to allow access to the EOS server from my SECONDARY ATT line (Note it is the secondary) 72.16.125.45 external address. Can you please let me know where/what I might be missing.
See attached Visio for visual reference.
In my Nat rules this is what I have made:
Traffic Source -> Any
Traffic Service -> Any (did any for testing to see if I could touch the server)
Traffic Destination -> External 2 Second IP Address (72.16.125.45)
Nat Mode: Full Nat
Destination -> EOS1 (10.4.11.1)
Destination Service -> blank
Source Internal secondary IP (10.10.1.2)
Source Service -> blank
Log inital -> yes
Automatic Packet filter rule -> no
Packet filter rule
Position -> 12
Source -> Any
Service -> Any
Destination -> EOS1
Action -> Allow
Time event -> Always
Log traffic -> Yes
This thread was automatically locked due to age.
