This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VOIP newbie

Hi All

I am thinking of having a voip phone sitting behind astaro but I don't know anything about  voip phones,equipment needed and so on.

I had a look at the forum (previous posts) and  support guides and I know how the setup should be. However, do you have any recommendations in terms of provider (I am in the UK and I want cheep international calls [:)] ) and equipment?

Thanks


This thread was automatically locked due to age.
Parents
  • With vonage, it's even easier than that.  You buy a little adapter box, which is basically a VOIP gateway that creates a tunnel to Vonage servers, which you can plug your existing POTS phone into.

    Best VoIP Equipment | VoIP Handsets from Vonage | VoIP Handset

    There's also Skype.  I remember a couple of years ago reading about some hardware based phone which work with Skype that operate in the same way as the vonage adapter (as oposed to just a soft-phone on your computer).

    To use a true standalone full VOIP phone, like one from Polycom, Cisco, Aastra, etc, you would need a VOIP PBX and a SIP-Trunk provider.  Too expensive for small installs.

    There's a general misunderstanding that with VOIP, you can just call directly to every other phone in the world, which is not true.  VOIP calls still need to enter the traditional POTS (Plain Old Telephone Service) system at some point.  This is where the provider (SIP-Trunk) comes in.  

    The big thing to look at is the pricing packages and restrictions, especially with international calls.
Reply
  • With vonage, it's even easier than that.  You buy a little adapter box, which is basically a VOIP gateway that creates a tunnel to Vonage servers, which you can plug your existing POTS phone into.

    Best VoIP Equipment | VoIP Handsets from Vonage | VoIP Handset

    There's also Skype.  I remember a couple of years ago reading about some hardware based phone which work with Skype that operate in the same way as the vonage adapter (as oposed to just a soft-phone on your computer).

    To use a true standalone full VOIP phone, like one from Polycom, Cisco, Aastra, etc, you would need a VOIP PBX and a SIP-Trunk provider.  Too expensive for small installs.

    There's a general misunderstanding that with VOIP, you can just call directly to every other phone in the world, which is not true.  VOIP calls still need to enter the traditional POTS (Plain Old Telephone Service) system at some point.  This is where the provider (SIP-Trunk) comes in.  

    The big thing to look at is the pricing packages and restrictions, especially with international calls.
Children
No Data