This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SIP Problems realy wear.

Hi Folks,

I have an really case here, with a client, he have an asg 220 with 8.120 firmware, packet filter rule from any, any service to any allow, I add all the servers of the VoIp and all the lans of the sip clients, when I make a call the phone rings in the branch office, a person hangs up, and I can talk to him, but with an incoming call, the phone here don´t rings, the person in the branch office says the phone hear like a call is working but no body answer, some more info:

The client have's a Office with an Cisco Asa in the perimeter, down our ASG 220 with packet filter with the any rule allowed all traffic, web proxy with some rules, no IPS. All the branch offices 3 in total, have an Cisco Asa to make the an IPSec vpn, before here have's an untangle server, and every thing works fine with the VoIP, but with our Asg have problems [:S] any ideas? Feel free to ask for information, cheers.

PS: I attach an txt with some lines of the packetfilter.


This thread was automatically locked due to age.
Parents
  • It appears that you have two segments bridged on the Astaro.  Since the blocks from .0.248 to .0.120 show with fwrule="60001", I guess that .0.120 is the IP address on the bridge - is that right?  What is the device at .0.248?  Does it have .0.120 as its default gateway?  Is there an External interface, or is the Astaro being run in bridge mode?

    Cheers - Bob
Reply
  • It appears that you have two segments bridged on the Astaro.  Since the blocks from .0.248 to .0.120 show with fwrule="60001", I guess that .0.120 is the IP address on the bridge - is that right?  What is the device at .0.248?  Does it have .0.120 as its default gateway?  Is there an External interface, or is the Astaro being run in bridge mode?

    Cheers - Bob
Children
  • It appears that you have two segments bridged on the Astaro.  Since the blocks from .0.248 to .0.120 show with fwrule="60001", I guess that .0.120 is the IP address on the bridge - is that right?  What is the device at .0.248?  Does it have .0.120 as its default gateway?  Is there an External interface, or is the Astaro being run in bridge mode?

    Cheers - Bob


    Hi Bob,

    Thank's for your answer, yes there 're two bridge's I ask this to one of my It's who install the Asg in demo, but now if fully funtional so the asg don't have to be any more in bridge more because the untagle is not there anymore, thank you very much for this, I don't check this before, cheers.