Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 10 replies
  • Subscribers 2 subscribers
  • Views 3005 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Set up servers with public IP

talbengal
Using ASG120
Firmware version: 8.102
eth0 - internal - 192.168.1.0/24
eth1 - External NTL
eth2 - internal - connect to Vigor2820 via switch with 5 public IP.

I would like all to go via ASG (from eth2) but when I do this all my servers lossing the public IP.

Can someone point me to the right configuration setting?


This thread was automatically locked due to age.
Parents
  • 0
    Hi, you could use a VLAN switch to setup a LAN and DMZ on the Internal NIC.

    Otherwise, you can still do additional addresses and DNATs on the external NICs, but if you don't have internal split DNS for the public internal servers, it can be difficult to access them internally.

    Barry
Reply
  • 0
    Hi, you could use a VLAN switch to setup a LAN and DMZ on the Internal NIC.

    Otherwise, you can still do additional addresses and DNATs on the external NICs, but if you don't have internal split DNS for the public internal servers, it can be difficult to access them internally.

    Barry
Children
No Data