This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sip and SSip problem

Hi,

I have a new voip server with some ports opened. I configured:
Traffic selector: Any → SIP → WAN (Address)
Traffic selector: Any → SIP over SSL →WAN (Address)

Where Wan is the interface to outside.

This config works and I can telnet from outside and connect, but this pbx software, has a firewall test which tries to telnet from server´s ip:5060/5061 to a external server:3478.

And fails...
Default DROP UDP 192.168.157.213:5060→96.9.132.83:3478

I added a firewall rule from this computer to ANY for sip and ssip but same error reported. any idea?

regards

This thread was automatically locked due to age.

Parents

0 equintana over 14 years ago

But 3cx software system needs a nat traffic to internet to run fine some services like queue manager.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 equintana over 14 years ago

But 3cx software system needs a nat traffic to internet to run fine some services like queue manager.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 RFCat_vk_01 over 14 years ago in reply to equintana

If you are using the gateway to convert the VoIP internal to the ISDN services then you will not need to configure the ASG to carry the traffic.

You will only need to configure the ASG if you are planning to talk to a VoIP provider, either an ISP or a trunk service.

At this stage I can't see what you are testing because you have not explained your requirements fully.

Please explain what you are trying to achieve eg a 3CX PABX to ISDN or 3CX PABX to VoIP trunk provider and what ports you need to use etc

Ian
Cancel
Vote Up 0 Vote Down

Cancel