This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Ooma & Astaro Issues

I have Ooma as my VoIP phone company and I am trying to get it to work through the ASG. I have the Ooma device in the SIP client networks configured as:

Type: Network
Interface: Internal
IPv4: 192.168.10.0/24
Netmask: 255.255.255.0
IPv6 Address: N/A
Netmask: 64 (Put here by default)
Comment: VoIP for Ooma device

In the VoIP section of the ASG where it says (SIP sever networks), I am not sure what information to put in there for the IP address? 

So far I have:

Type: Network
Interface: Any (Should I select Uplink Interface instead)?
IPv4 Address: Not sure what to put here
IPv6 Address: N/A
Netmask: 64 (Put here by default)
Comment: VoIP for Ooma device

Any help on this is greatly appreciated.  FYI: I am very new to Astaro and learning as much as I can, so please be gentle.   :-)

Thanks.


This thread was automatically locked due to age.
Parents
  • Hi, your definition for the SIP device should be for a single IP (of the SIP adapter), not your entire internal Class C network.

    Then you would put that definition in the VOIP Security section under SIP Client networks.

    The SIP Server networks would be the network(s) of Ooma. You could ask them, or use a sniffer, for their network addresses.
    I think it is acceptable to use the Internet definition there as well, at a slight loss of security.

    Barry
Reply
  • Hi, your definition for the SIP device should be for a single IP (of the SIP adapter), not your entire internal Class C network.

    Then you would put that definition in the VOIP Security section under SIP Client networks.

    The SIP Server networks would be the network(s) of Ooma. You could ask them, or use a sniffer, for their network addresses.
    I think it is acceptable to use the Internet definition there as well, at a slight loss of security.

    Barry
Children
No Data