This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Private DMZ and NAT Issue

Please point me to another post if it has the answer.

We have a customer that has two internet sources that connect to the Astaro as follows.  The Astaro is an ASG220 running 7.503.

Internet -> Astaro -> LAN
Internet -> 3rd Party Firewall -> DMZ -> Astaro -> LAN

The 3rd Party firewall only purpose is to provide access to two specific destinations via tunnels and not any general internet traffic.  It also does not have any routing capability built into it.  The problem this presents is that I have to setup the Astaro to NAT all LAN traffic bound for this 3rd Party Firewall from the LAN to the DMZ IP (and back again).  Needless to say, I am having trouble with this as I keep getting Invalid Parameter errors.

I cannot change the devices and I cannot move the tunnels.

Any assistance would be helpful.  I would discuss what I've tried, but I feel like I've tried every iteration except the one that would work.  

Attached is an image of the setup in case my description is confusing.

Thank you,

Jason


This thread was automatically locked due to age.
Parents
  • If you can't set the Astaro as the default gateway for the LANs, and you can't put a route into the 3pFW, how can there be any solution with any device, Astaro or other?  The only thing remaining is manual routes in all devices on the LANs that need to get to the Internet but not one of the sites handled by the 3pFW.

    Cheers - Bob
Reply
  • If you can't set the Astaro as the default gateway for the LANs, and you can't put a route into the 3pFW, how can there be any solution with any device, Astaro or other?  The only thing remaining is manual routes in all devices on the LANs that need to get to the Internet but not one of the sites handled by the 3pFW.

    Cheers - Bob
Children
No Data