This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

QoS for VoIP via IPSec VPN

Hello,

I couldn't find an answer to the subject question. My company has two locations, both protected by Astaro ASG220 (with separate Internet access):
Site1: 3 mbit/s (symmetrical)
Site2: 1.5 mbit/s (symmetrical)

There are two parallel VPN channels for site-to-site (s2s):
1. SSL VPN, connecting two remote sites for user data exchange, etc.
2. IPSec VPN, connecting two remote networks with Avaya IP Office 500 phone system equipment (basically, only two control units facing each other over the VPN via their VoIP interfaces).

The Avaya Phone sytem configured with the following DiffServ settings:
DSCP (Hex): B8; DSCP: 46
DSCP Mask (Hex): FC; DSCP Mask: 63
SIG DSCP (Hex): 88; SIG DSCP: 34
It requires 8 channels by 64 kbit/s per channel for s2s connection bandwidth. I was suggested by the phone system supplier to use 8 x 80 = 640 kbit/s calculation.

Two VPNs and Internet traffic obviously compete with voice traffic at External interfaces of each Astaro.

Here is what I did with great help of Bob (BAlfson):

1. On External interfaces (Network/Quality of Service), I activated QoS on External:
Site1: Downlink kbit/s: 3072; Uplink kbit/s: 3072; Download Equalizer, Upload Optimizer (Limit Uplink unchecked)
Site2: Downlink kbit/s: 1536; Uplink kbit/s: 1536; Download Equalizer, Upload Optimizer (Limit Uplink unchecked)

2. Created the following traffic selectors (not too sure if this part is right):
 * VoIP over IPSec VPN 46: External --> IPSec --> [Public IP of the other Astaro]; DSCP-Bits value: 46
 * VoIP over IPSec VPN 26: External --> IPSec --> [Public IP of the other Astaro]; DSCP-Bits value: 26
 * VoIP over IPSec VPN 63: External --> IPSec --> [Public IP of the other Astaro]; DSCP-Bits value: 63
 * VoIP over IPSec VPN 34: External --> IPSec --> [Public IP of the other Astaro]; DSCP-Bits value: 34

3. On External interface (of each Astaro) created Bandwidth Pools:
 * VoIP over IPSec VPN. Bandwidth (kbit/s): 640 kbit/s, including all four traffic selectors above.

To test this, I started copying a large file across the sites, and phoned somebody on the other site. It was not very good, some packets were dropped (intermittent voice), some packets were disordered (pro-pa-gate would sound sometimes like pro-gate-pa). But overall, it was much better than without any QoS.

I guess, I need to define some additional traffic selectors, according to the DiffServ specs. It is also important not to add any non-VoIP traffic selectors to the Bandwidth Pools.

I know, the solution exists, we just have to find it, and it would be a great knowledge for everyone. I would greatly appreciate any help, in particular, how to configure DiffServ on Astaro.


This thread was automatically locked due to age.
Parents
  • Astaro only applies QoS rules when packets leave an interface. Incoming packets arrive on one interface, but a QoS rule cannot be applied until it is leaving another interface. By slowing the packets of some sessions as they leave an interface, Astaro can limit the transfer rate of some sessions, and make bandwidth available for others.
Reply
  • Astaro only applies QoS rules when packets leave an interface. Incoming packets arrive on one interface, but a QoS rule cannot be applied until it is leaving another interface. By slowing the packets of some sessions as they leave an interface, Astaro can limit the transfer rate of some sessions, and make bandwidth available for others.
Children
  • Thank you so much guys for your great help!

    Eventually, my phone system registers no packets being lost!
    However, when I did testing, I generated a high volume Internet traffic at both sites, and phoned to the other site again. There was no packets missed or disordered, but for some reason, voice was like a low bit rate sound. Imagine a sound with bit rate of ~8 kbit/s... Under normal load, sound is clear. I spoke to the phone system supplier, the codec is G.711 ULAW 64k, and it doesn't change the compression, it is always 64k, so it has nothing to do with this.

    Maybe I did my traffic selectors wrong?

    Here is my configuration now (identical for each site):

    1. Site-to-Site VPN / IPSec / Advanced: Copy TOS (Type of Service) value SELECTED!

    2. The declared bandwidth of the IPOfficeInternal interface has been reduced to match the Internet connection speed.

    3. External interface traffic selectors (used to create External ITF Bandwidth Pool):
     - VoIP over IPSec VPN 46: External --> IPSec --> [Public IP of the other Astaro]; DSCP-Bits value: 46
     - VoIP over IPSec VPN 63: External --> IPSec --> [Public IP of the other Astaro]; DSCP-Bits value: 63
     - VoIP over IPSec VPN 34: External --> IPSec --> [Public IP of the other Astaro]; DSCP-Bits value: 34

    4. Internal interface traffic selectors (used to create IPOfficeInternal ITF Bandwidth Pool):
     - VoIP local 46: IPOfficeInternal --> Any --> IPOfficeNetwork; DSCP-Bits value: 46
     - VoIP local 63: IPOfficeInternal --> Any --> IPOfficeNetwork; DSCP-Bits value: 63
     - VoIP local 34: IPOfficeInternal --> Any --> IPOfficeNetwork; DSCP-Bits value: 34

    How does this co-relate with the phone system DiffServ specification:
    DSCP (Hex): B8; DSCP: 46
    DSCP Mask (Hex): FC; DSCP Mask: 63
    SIG DSCP (Hex): 88; SIG DSCP: 34


    I set the traffic selectors just by guessing. Did I do it right? I hope, here is the source of the LAST problem.
  • Sorry, forgot to add:
    Both External and IPOfficeInternal interfaces have these unchecked:
     * Download Equalizer - unchecked
     * Upload Optimizer - unchecked
    I tested with these being ON and OFF, the voice quality was better with "OFF" (under the same other conditions: high volume Internet traffic).