Group,
Good afternoon. I have tried to configure my astaro firewall with 2 different public ip address. When i set up the ip address of .14 and .15 in the additional address area with the sub mask of /32. I do not get any traffic at all on the ip address. This is after i setup a NAT as well to take traffic from .14 to my internal ip address of .9 on port 80.
I am able to ping both .14 and .15. But no outside traffic at all. My NAT is setup as follows:
Select DNATtab
New NAT rule
Name: Webserver traffic
Group: No group
Position: Bottom
Traffic Source: Any
Traffic Service: HTTP & Portal 8000
Traffic Destination: External webserver (address)
NAT Mode: DNAT (destination)
Destination: Webserver
Destination Service: left blank
Click Save
I am not able to get any traffic on either .14. and .15. Any help is greatful.
Best regards,
KC
This thread was automatically locked due to age.