This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot Create New DNAT Rule

I have an existing ASG120 where I have created a DNAT rule in the past. It is currently running at verson 7.502. When I attempt to create a new NAT rule, and using the first rule as a template, I get the following notification:

'Configuration is Logically Incorrect'

So, are there new restrictions on services in DNAT that are now enforced with the 7.5xx code?

This thread was automatically locked due to age.

Parents

0 BarryG over 15 years ago

Hi,

Normally, Astaro is right, and something is wrong with the configuration.

Please post screenshots of the configuration which generates the error.

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 robertobrinsky over 15 years ago in reply to BarryG

I was just now able to create the DNAT rule by leaving the destination services blank - I found that finally in another thread. Now I need to figure out why my rule is not working, but that is another matter. Thanks for the reply.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 robertobrinsky over 15 years ago in reply to BarryG

I was just now able to create the DNAT rule by leaving the destination services blank - I found that finally in another thread. Now I need to figure out why my rule is not working, but that is another matter. Thanks for the reply.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data